Ultimate-speed ULSP 2 A1 Manual do Utilizador descarregar pdf (Página 9)

ULSP 2 A1

Measuring procedure

Normal measuring mode

CAUTION

► Place the device carefully on the surface to be meas-

ed, and do not move it during measuring. Remove

the device carefully from the surface after measuring,

otherwise you could cause scratches on the paintwork.

♦ Remove the protective cap

and switch the device on

(standby mode).

♦ Keep the device away from any surfaces and then press

the TEST button

. The red LED will illuminate perma-

nently and the device is now in normal measuring mode.

♦ Place the measuring sensor

at right angles to the

surface to be measured. The measured paint thickness

will be signalised by one of the three LEDs illuminating

(see table).

LED colour Paint thickness

Red > approx. 1.8 mm

Yellow approx. 1.0–1.8 mm

Green < approx. 1.0 mm

♦ Press the TEST button

again to return to standby mode.

The red LED ﬂ ashes.

IB_91055_ULSP2A1_SK_RO_OS.indb 6IB_91055_ULSP2A1_SK_RO_OS.indb 6 22.07.13 11:5322.07.13 11:53

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 43 44

Sem comentários

Ultimate-speed ULSP 2 A1 Manual do Utilizador Página 9